Home About Us Gallery Products Contact Us
Www.LaSpeedometerGear.com www.manualtransmissionkits.com www.americanhotrodsolutions.com www.adapt-a-case.com www.superior-transmission.com www.gopnh.com www.tcsproducts.com www.raybestospowertrain.com

RCP96-140 4L60E Z-PAK CLUTCH MODULE

FITS 1987-UP 700R4 AND 4L60E. COMES WITH Z-PAK 3-4 FRICTIONS TO MAXIMIZE THE 3-4 CAPACITY. THIS IS ATOP QUALITY CLUTCH MODULE.

Z Pak™ is the patented, single-sided clutch system that outperforms OE in torque and heat capacity without coning. For new OEM platforms, the Z Pak design can reduce the overall size of the clutch pack for a smaller, lighter assembly with greater thermal capacity. On existing designs, the single-sided plate can increase torque capacity and reduce core temperatures for a significant reduction in hot spotting and greater clutch life. And Z Pak takes the heat without coning. When used with the revolutionary X-32™ friction material developed by Raybestos, the Z Pak™ system outperforms OE by as much as 30%.

LOW/REV. ONE WAY CLUTCH

THIS FITS 700R4 1986-UP. THE WIDE LOW REVERSE SPRING AND ROLLER CAN BE RETRO’D BACK TO 1982 WITH THE USE OF A LATE CENTER SUPPORT

CORVETTE SERVO

THIS IS THE WORLD RENOWNED CORVETTE SERVO, THE LARGEST RATIO GM EVER MADE AND WAS USED IN ALL THEIR HIGH PERFORMANCE VEHICLES. THIS IS A GREAT UPGRADE TO ANY TRANSMISSION REBUILD.

GM 700R4/4L60E Bearing Kit

  1982-Up This bearing kit includes the bearings for: stator to input drum, input drum to sun gear, rear hub to case, rear planet to support, and output shaft to case. These are Koyo bearing kits which are the highest quality bearings you can put back in your transmission.

4L60/4L60-E Super Servo 4th apply piston & cover (Superior K034 )

Super Servo

* 4th apply piston and cover * Better holding capacity in 4th gear * Lip seal design on piston (less leakage) * Proper 4-3 (no drag) release * Constructed of billet aluminum

GM 700-R4 4L60 1982-On Complete Bushing Kit

This bushing kit includes a, pump, case, extension housing, front stator, rear stator, both input sun gear, rear sun gear, reaction shaft front, reaction shaft rear, reverse drum front, and reverse drum rear


700R4/4L60E/2004R 4TH GEAR LOCK-UP SOLENOID

Splice in design Lock Up Solenoid.Quick connection clips make installation a breeze on this lock-up solenoid kit .This will fit all 2004R , 700R4 , & 4L60E models , and includes a basic instruction sheet . This is the standard replacement design. Great for applications when you do not need to replace the entire harness

HEAVY DUTY

4L60E  4L65E  700R4

'82+ 4-SPEED AUTOMATIC TRANSMISSIONS

(WITH 16 BOLT PAN)

SPECIAL 4-TANG WASHER INCLUDED

IT IS ALWAYS RECOMMENDED TO REPLACE THIS SHELL ON EVERY REBUILD

THIS IS THE ORIGINAL BEAST SUN GEAR SHELL , NOT A COPY!

PROUDLY MADE IN THE USA

PHOTO SHOWS ACTUAL HARDENED STEEL SUN GEAR SHELL & WASHER

REPLACES GM AC-DELCO 24228345

ALL THREE MOLDED PISTONS FOR THE INPUT DRUM

ALLOMATIC TRANSMISSION FILTER.

 2WD OR 4WD, DEEP OR SHALLOW PAN, EARLY OR LATE

4L60-E Boost Valve And Sleeve (Superior K021)


Problem Solver


* Replaces worn out O.E. aluminum valves. * Made of hardened steel to resist wear. * Proper tolerance assured at bore mating surfaces. * Cover years 1993 - 2004

29 ELEMENT INPUT SPRAG

DOUBLE CAGE 29 ELEMENT SPRAG FITS 1987-UP 700R4 AND 4L60E  COST $43.50

REVERSE INPUT DRUM

THIS IS A BRAND NEW AFTER MARKET DRUM. THIS AFTER MARKET IS BETTER THAN O.E. THAT DOESN'T HAPPEN OFTEN. THIS DRUM IS MADE BETTER THAN O.E. SPEC. THESE DRUMS ARE OFTEN WORE OUT IN THE TRANSMISSION AND NEED REPLACEMENT JUST ABOUT EVERY TIME.

700R4/4L60E 13 VANE ROTOR KIT

 700R4 / 4L60E high performance / high volume pump rotor kits. Turn your seven or ten vane pump into a thirteen vane pump. This kit will eliminate irregular pump pressure above 5,000 RPM. Transmission must be removed to install this kit. (When using a 13 vane pump don't raise the motor speed above idle until the transmission is full of fluid, doing so may break the pump rotor.)

TRANSGO 4L60E SHIFT KIT

 (SK-4L60E)

FITS 4L60E/65E/70E 93-10 NON-HYBRID

This kit is a must for this transmission, not only does it shift quick, clean, smooth and nice, but it addresses the most serious complaints that have plagued this unit over the years. With this kit durability and dependability are greatly increased, plus you or your customer will love the way it works.

700R4 THRUST WASHER KIT

A complete thrust washer kit for the popular GM and Chevy 700R4, 4L60E overdrive automatic transmissions from 1982-up. This includes all of the washers in the transmission for 700R4, 4L60, 4L60E, 4L65E. A total of 7 thrust washers in all. If you need a complete rebuild kit, check out our COMBO KIT PAGE.


RAYBESTOS PRO SERIES WIDE 2-4 BAND

THIS IS THE BEST BAND ON THE MARKET. IT USES ALL AVAILABLE SURFACE ON THE DRUM. FOR USE WITH A NEW DRUM ONLY. THIS BAND IS A MUST ON HIGH PERFORMANCE REBUILDS.

4L60E TOLEDO OVERHAUL KIT FITS 93-2003

TOLEDO TTK IS THE BEST QUALITY OVERHAUL KIT ON THE MARKET.THIS OVERHAUL KIT WILL CONSIST OF THESE ITEMS;ALL THE RUBBER SEALS AND O'RINGS FOR THE TRANSMISSION.ALL THE PAPER GASKETS FOR THE TRANSMISSION.HIGH QUALITY TOP OF THE LINE FIBER PAN GASKET.

NOK FRONT PUMP HARD METAL CLAD SEAL.NOK REAR TAIL HOUSING METAL CLAD SEAL.

NOK COMPLETE SEALING RING KIT.PUMP NYLON OIL FILTER SCREEN.

GOVERNOR NYLON OIL FILTER SCREEN.TCC/PRESSURE NYLON OIL FILTER SCREEN.

NEW OEM SNAP RING FOR THE FRONT PLANET TO OUTPUT SHAFT. THESE ARE THE KITS THE PROFESSIONALS USE.  DON'T SETTLE FOR LESS.

THIS IS A BUILT RIGHT LEVEL 1 KIT FOR THE 4L60E TRANSMISSION

BUILT PROPERLY THIS KIT WILL HANDLE 550HP

ALL THE GUESS WORK HAS BEEN DONE FOR YOU. COST $585.00

SPECIFY YEAR WHEN ORDERING. FREE SHIPPING.